Аксессуары для 3D-принтера низкой и высокой температуры, комплект замены V6 BP6 Hotend Kit J-head Extruder с соплом 0,4 мм, диаметром 1,75 мм.

Аксессуары для 3D-принтера низкой и высокой температуры комплект замены V6 BP6 Hotend Kit J-head Extruder с соплом 0 4 мм диаметром 1 75 мм.

3D Printer Accessories High-Temp Low-Temp Replace V6 BP6 Hotend Kit J-head Extruder With 0.4mm 1.75mm Nozzle 

BP6 Hotend Module Product quality description:

High temperature module: stainless steel material, no ferrofluron tube inside, only reserved the hole diameter of consumable material, suitable for over 250 degrees of high temperature consumable material.For example, Nylon, PC, etc.

Note: The High Temperature module can also print the PLA filament, but because the tube inside are all metal, and the thermal conductivity is good, which is easy to make the heat to the whole tube, and result in the material to melt in advance, and then the clugging happens. So if you print PLA with the High Temperature module, you should set the temperature well. If only or usually for printing PLA,  the Low temperature module is recommended.

About the color changed after some time use of the heating blocks:

Due to technology limited, the anodized metal surface color is only for appearance use. After the use of aluminum block, the color will change because the color dye on the metal surface will get evaporated during the high temperature heating, including the natural aluminum block, just not that obvious. (For example, a black frosted heating block will turn yellow when it is heated at a high temperature). But it will not affect the use at all. It is not a quality problem. If you mind this, please consider twice before you decide to buy it, or you can buy a frosted silver or natural color heating block, the color changes not so obvious.